Than water. The 95 DMSO solvent is able to dissolve fibrils to unfolded amylin monomers, giving a twodimensional (2D) Eliglustat 1H-15N HSQC spectrum and 15N-edited 1D spectrum (Figure S3) comparable to that obtained when unfibrillized amylin is dissolved in 95 DMSO. It has been previously reported that amylin fibrils are insoluble in DMSO [28,30]. Unlike the naturally occurring hormone the 15N-labeled amylin used in this work is not amidated at its C-terminus, which may increase the solubility of fibrils in DMSO. A second important difference is that the fibrils used in this work were prepared from a pure preparation of amylin, whereas in the previous study [30] amylin fibrils were isolated from a pancreatic tumor where they may have been associated with cofactors [31] that could affect stability and solubility in DMSO.Materials and Methods MaterialsRecombinant 15N-amylin was purchased 23727046 as a lyophilized powder from rPeptide (Bogart, GA). The peptide was expressed in Escherichia coli and has an intact C2 7 disulfide bond but differs from human amylin by not having an amidated C-terminus, which is an enzymatic post-translational modification in mature human amylin [4]. D2O (isotope purity .99.96 ) and DMSO-d6 (99.96 ) were from CIL (Andover, MA). Dichloroacetic acid (DCA) was from Aldrich (St. Louis, MO) and deuterated dichloroacetic acid: Cl2CDCO2D, 99.7 (d2-DCA) was from CDN Isotopes (Point-Claire, Quebec, Canada).Amylin Fibrillization and Quenched Hydrogen Exchange ExperimentsA 1.4 mg sample of 15N-amyin was dissolved in 140 ml of acetonitrile to disrupt any preexisting aggregates, and taken up in 1.26 ml of 20 mM sodium phosphate buffer, pH 7.4. The resulting amylin concentration for fibrillization was 250 mM. The final concentration of acetonitrile in the fibrillization buffer was 10 (v/v). A concentration of 0.02 NaN3 (w/v) was added to prevent bacterial growth during fibrillization. Following dissolution, the solution was sonicated continuously for 1 minute at 75 power to break up any potential aggregates. To form fibrils, the sample was incubated at 37uC without agitation in a low-retention Eppendorf tube for 116 h (,5 days). Fibrils were collected by sedimentation for 45 min at 15,000 g in an Eppendorf desktop micro-centrifuge. The pellet of approximately 40 ml volume was resuspended in 1.24 ml of 99.96 D2O and the pH of the suspension was determined to be 7.6. The H2O/D2O dilution factor for was ,31fold, corresponding to a final concentration of at most 3 H2O in the sample. For the hydrogen-deuterium exchange reaction, the sample was maintained at 37uC in an EchoTherm IN30 incubator from Torrey Pines Scientific (Carlsbad, CA). To 298690-60-5 monitor HX, 0.2 ml aliquots were withdrawn at seven time points: 0.08, 1, 8, 24, 73, 99 and 356 h. The fibril suspension in D2O was mixed for 30 s with a Fisher Vortex Genie-2 before each aliquot was withdrawn. The aliquots were immediately frozen in a dry ice/ethanol bath, lyophilized, and stored at 280uC until use. For NMR experiments, the partially exchanged lyophilized fibrils were dissolved in 0.5 ml of 95 d6-DMSO/5 d2-DCA. Note that deuterated d2-DCA was used for NMR experiments to prevent back-exchange of protons from the acid to amylin. The pH of each sample was checked after the NMR experiments and was pH* 3.460.1.Control Experiments to Demonstrate the Solubility of Amylin Fibrils in DMSOThree control experiments were done to verify that amylin fibrils are soluble in DMSO and to optimize the co.Than water. The 95 DMSO solvent is able to dissolve fibrils to unfolded amylin monomers, giving a twodimensional (2D) 1H-15N HSQC spectrum and 15N-edited 1D spectrum (Figure S3) comparable to that obtained when unfibrillized amylin is dissolved in 95 DMSO. It has been previously reported that amylin fibrils are insoluble in DMSO [28,30]. Unlike the naturally occurring hormone the 15N-labeled amylin used in this work is not amidated at its C-terminus, which may increase the solubility of fibrils in DMSO. A second important difference is that the fibrils used in this work were prepared from a pure preparation of amylin, whereas in the previous study [30] amylin fibrils were isolated from a pancreatic tumor where they may have been associated with cofactors [31] that could affect stability and solubility in DMSO.Materials and Methods MaterialsRecombinant 15N-amylin was purchased 23727046 as a lyophilized powder from rPeptide (Bogart, GA). The peptide was expressed in Escherichia coli and has an intact C2 7 disulfide bond but differs from human amylin by not having an amidated C-terminus, which is an enzymatic post-translational modification in mature human amylin [4]. D2O (isotope purity .99.96 ) and DMSO-d6 (99.96 ) were from CIL (Andover, MA). Dichloroacetic acid (DCA) was from Aldrich (St. Louis, MO) and deuterated dichloroacetic acid: Cl2CDCO2D, 99.7 (d2-DCA) was from CDN Isotopes (Point-Claire, Quebec, Canada).Amylin Fibrillization and Quenched Hydrogen Exchange ExperimentsA 1.4 mg sample of 15N-amyin was dissolved in 140 ml of acetonitrile to disrupt any preexisting aggregates, and taken up in 1.26 ml of 20 mM sodium phosphate buffer, pH 7.4. The resulting amylin concentration for fibrillization was 250 mM. The final concentration of acetonitrile in the fibrillization buffer was 10 (v/v). A concentration of 0.02 NaN3 (w/v) was added to prevent bacterial growth during fibrillization. Following dissolution, the solution was sonicated continuously for 1 minute at 75 power to break up any potential aggregates. To form fibrils, the sample was incubated at 37uC without agitation in a low-retention Eppendorf tube for 116 h (,5 days). Fibrils were collected by sedimentation for 45 min at 15,000 g in an Eppendorf desktop micro-centrifuge. The pellet of approximately 40 ml volume was resuspended in 1.24 ml of 99.96 D2O and the pH of the suspension was determined to be 7.6. The H2O/D2O dilution factor for was ,31fold, corresponding to a final concentration of at most 3 H2O in the sample. For the hydrogen-deuterium exchange reaction, the sample was maintained at 37uC in an EchoTherm IN30 incubator from Torrey Pines Scientific (Carlsbad, CA). To monitor HX, 0.2 ml aliquots were withdrawn at seven time points: 0.08, 1, 8, 24, 73, 99 and 356 h. The fibril suspension in D2O was mixed for 30 s with a Fisher Vortex Genie-2 before each aliquot was withdrawn. The aliquots were immediately frozen in a dry ice/ethanol bath, lyophilized, and stored at 280uC until use. For NMR experiments, the partially exchanged lyophilized fibrils were dissolved in 0.5 ml of 95 d6-DMSO/5 d2-DCA. Note that deuterated d2-DCA was used for NMR experiments to prevent back-exchange of protons from the acid to amylin. The pH of each sample was checked after the NMR experiments and was pH* 3.460.1.Control Experiments to Demonstrate the Solubility of Amylin Fibrils in DMSOThree control experiments were done to verify that amylin fibrils are soluble in DMSO and to optimize the co.